Machine Problems - Fuji Xerox DocuCentre S2010 User Manual

Machine Problems

Check the machine's status again if you suspect a malfunction.
Symptom
The machine is
not powered on.
The <Error>
indicator is
blinking.
The <Error>
indicator is lit.
The display is
dark.
Unable to print
or copy.
The <Data>
indicator does
not light even
though you
instructed the
machine to print.
Unable to print
although a print
job is instructed
to Bypass tray.
Possible Cause
Is the power switched ON?
Is the power cord plugged
into the power outlet?
Is the power cord
disconnected from the
machine?
Does the AC outlet supply
power properly?
The system of the machine
or the components installed
may have a trouble.
Is paper or document
jammed?
Is the machine front cover
or another cover open?
Is the <Energy Saver>
button lit?
Is there an error code
displayed in the control
panel's display?
Is the power cord
connected?
Is the interface cable
connected?
Is the computer's
environment correctly set?
Is the required port status
set to [Enabled]?
Is the specified paper size
loaded in the tray?

Machine Problems

Remedy
Switch the power ON.
Refer to "Power Source" (P.52).
Switch the power OFF and make sure the
power plug is inserted securely. Then
switch the power ON.
Connect another appliance to the outlet to
verify the power supply.
Switch the power OFF, then ON again. If
the problem persists, contact our Customer
Support Center.
Remove the jammed paper or document.
Refer to "Paper Jams" (P.179).
Refer to "Document Jams" (P.184).
Follow the instructions in the displayed
error code to take the required action.
Refer to "Error Code" (P.172).
The machine is in an energy saver mode.
Press the control panel's <Energy Saver>
button to turn off the energy saver mode.
Follow the instructions in the displayed
error code to take the required action.
Refer to "Error Code" (P.172).
Switch the power OFF and make sure the
power plug is inserted securely into the
power outlet. Then switch the power ON.
Check the interface cable connection.
Refer to "Interface Cables" (P.29).
Check the computer environment such as
print driver settings.
Check the status of the port to use, and
then set the port status to [Enabled].
Refer to "Activating the Communication Port
To Use" (P.32).
Follow the instructions in the displayed
error code to place paper of the correct
size, and then try again.
Refer to "Error Code" (P.172).
Refer to "Loading Paper in Bypass Tray"
(P.76).
11
149