Fuji Xerox DocuCentre S2010 User Manual page 176

11 Problem Solving
Error code (XXX-XXX)
11
176
Error Code
The drum cartridge is defective.
Reached the maximum copy limit
while the limit is set. Also, the user
who reached the copy job limit has
logged in.
A job is canceled due to out of
memory in reading.
A job is canceled.
Error Code
004-345
An error occurred.
005-210
An error occurred.
005-275
An error occurred.
005-280
An error occurred.
005-500
An error occurred.
005-940
An error occurred in the document
feeder.
Cause
Replace the drum cartridge
immediately. Otherwise, the
machine will be damaged.
Refer to "Replacing the Drum
Cartridge" (P.142).
Press the <Stop> button, and
contact your system administrator.
Change the setting, and then try
again.
Change the setting, and then try
again.
Cause
Switch off the machine power, make
sure that the display is blank, and
then switch on the machine power.
Switch off the machine power, make
sure that the display is blank, and
then switch on the machine power. If
the same error code is displayed
again, contact our Customer
Support Center.
Switch off the machine power, make
sure that the display is blank, and
then switch on the machine power.
Switch off the machine power, make
sure that the display is blank, and
then switch on the machine power. If
the same error code is displayed
again, contact our Customer
Support Center.
Switch off the machine power, make
sure that the display is blank, and
then switch on the machine power.
When finished copying, proceed one
of the followings: press any button
on the control panel, execute new
job, or wait until the machine
reaches the time out to releases the
error.
Remedy
Remedy