Paper Jams - Fuji Xerox DocuCentre S2010 User Manual

Paper Jams

This section describes procedures to clear paper jams.
When paper jams in the machine, the machine stops, and a tray indicator and the
Paper/Document Jam icon on the status machine diagram (mimic) light up. An error
code also appears in the display, which indicates which procedures to take to remove
the jammed paper.
Carefully remove the jammed paper without tearing it. Do not leave any pieces of paper
in the machine.
Note
WARNING
If you need to pull out a tray to remove paper jam, contact your local Fuji Xerox
representative. Do not pull out a tray, otherwise it may cause injuries.
CAUTION
Do not attempt to remove a paper deeply jammed inside the product, particularly a
paper wrapped around the fusing unit or the heat roller. Otherwise, it may cause
Injuries or burns. Switch off the product immediately and contact your local Fuji Xerox
representative.
This section describes the procedures to remove the jammed paper from the following
locations.
The following shows the reference section for the procedures to clear a paper jam in
each location.
E-1: Paper Jam in Left Cover [A] ............................................................................................ 180
E-2: Paper Jam in One Tray Module Cover [B]....................................................................... 181
E-3: Paper Jams in Tray 1 ........................................................................................................ 182
E-4: Paper Jams in Tray 2 ........................................................................................................ 182
E-5: Paper Jams in Bypass Tray............................................................................................... 183
Important • Pulling out a tray after a paper jam without checking where the jam is located may cause the
• If a paper jam error code remains in the display after you have removed the jammed paper,
it is possible that paper is jammed in another location in the machine or that pieces of paper
are still left in the machine. Check the status machine diagram (mimic) and the error code,
and remove the jammed paper completely.
• After removing the jammed paper, a copy job resumes automatically.
• A print job resumes automatically from the page being printed just before the paper jam
occurred.
• While running a copy job using the document feeder without collating the copied output
(meaning that the document feeder feeds and scans the documents one sheet at a time), if a
paper jam occurs on the machine, the machine resumes to make a copy of the already
scanned document automatically after removing the jammed paper. However, as for the
remaining document, you must press the <Start> button again to allow the document feeder
to feed and scan the rest of the loaded documents.
paper to tear and leave shreds inside the machine. To prevent equipment failure, check the
location of paper jams before attempting to clear them.
• The paper jam display will not go out if paper shreds remain in the machine.
• When clearing paper jams, leave the machine's power ON. Switching the power OFF erases
information stored in the machine's memory.
• Do not touch parts inside the machine. Printing errors may result.

Paper Jams

11
179