Setting The Paper Size - Fuji Xerox DocuCentre S2010 User Manual

4 Loading Paper

Setting the Paper Size

This section describes how to set the paper size and orientation for Trays 1 and 2.
After you load paper, make sure to set the size and orientation of the paper loaded into
the tray.
Note
1
Press the <Paper Supply> button to select a
tray where the paper you will specify the paper
size and orientation is loaded.
In the status machine diagram, the tray
indicator lights up on the selected tray, and its
paper size and orientation are displayed on the
paper size display.
2
Press and hold the <Size (Press 2sec) >
button for more than 2 seconds until the paper
size in the paper size display area starts
4
blinking.
The paper size in the paper size display area
blinks and the machine enters paper size
setting mode.
3
Press the <Size (Press 2sec)> button to select the size and orientation of the paper
loaded in the selected tray.
The selected paper size and orientation are displayed in the status machine diagram.
The <Start> button lights up blinking during the settings.
4
Press the <Start> button to confirm the settings.
To exit paper size setting mode without saving the settings, press the <Clear All>
button or the <Stop> button.
Important • Be sure to press the <Start> button. Otherwise the settings of paper size and orientation are
80
• You cannot change the setting while the machine is processing a job.
canceled and remain the previous settings.
<Paper Supply> button
<Size (Press 2sec)> button