Setting The Ventilation Breath Type And Mode; Adult And Pediatric Mode Select Screen; Infant Mode Select Screen - CareFusion AVEA Operating Instructions Manual

66

Setting the Ventilation Breath Type and Mode

To access the Mode selection options, press the Mode membrane button to the left of the LCD screen.
Figure 3–10: Adult and Pediatric Mode Select screen
Figure 3–11: Infant Mode Select screen
The choices displayed in the Mode Select screen are a combination of breath type and ventilation delivery mode (e.g. a
Volume limited breath with Assist /Control ventilation is shown as Volume A/C). APNEA Backup ventilation choices
appear when CPAP/PSV or APRV / BIPHASIC mode is selected. Apnea Backup is active in all Assist Control, SIMV,
APRV / BIPHASIC and CPAP/PSV modes.
Note:
When CPAP/PSV or APRV / BIPHASIC (Airway Pressure Release Ventilation) is selected, you MUST
1. Set the primary and advanced settings for CPAP/PSV or APRV / BIPHASIC
2 Select the breath type for APNEA backup mode by pressing the Apnea Settings key
3 Set the primary and advanced controls visible at the bottom of the touch screen, for the selected apnea breath
type before pressing the MODE ACCEPT button. The controls for the apnea breath type will not be visible once
the MODE ACCEPT button has been pressed. Only those controls that are active and required for CPAP/PSV or
APRV / BIPHASIC will remain. To review the Apnea backup settings press the Mode button at any time and select
APNEA Settings.
Chapter 3: Ventilator Operation Operator's manual
L2786 Rev. M