Humidifier; Patient Weight; Identification - CareFusion AVEA Operating Instructions Manual

AVEA ventilator systems

Humidifier

You can select active or passive humidification (ON/active or OFF/passive). Active humidification assumes 99% RH;
passive assumes 60% RH when using an HME. This feature adjusts the BTPS correction factor to correct exhaled tidal
volumes.
Range: Active ON/OFF
Default: Active ON
Note:
Incorrect setting of the Humidification feature will affect monitored exhaled volume accuracy

Patient Weight

Patient Weight can be set in the following ranges.
Patient weight is a variable determined by the clinician and is used for the purpose of displaying monitored volume per
unit weight.

Identification

Patient ID. You may input a 24-character (two x 12-character), alphanumeric patient identification. To create a patient
ID, press the Touch Screen directly over the Patient IDENTIFICATION field.
A secondary screen appears showing the characters available for patient identification. Turn the data dial at the bottom
of the UIM (Figure 3–7) to scroll through the characters. Press the ACCEPT membrane key to accept each character
and build your Patient ID code. When the Patient ID code is complete, once again press the Touch Screen directly over
the Patient IDENTIFICATION field to accept the entire Patient ID code.
Check the rest of the screen parameters and if you are satisfied with the setup, press the SETUP ACCEPT button.
Figure 3–7: Data Dial, Accept & Cancel Button
Note:
Primary breath controls active for the selected (highlighted) mode are visible at the bottom of the touch screen during
setup. The Advanced Settings dialog box and the Alarm Limits dialog box can also be opened during setup. All
controls are active and may be modified while in the Set Up screen.
L2786 Rev. M
Chapter 3: Ventilator Operation
Adult 1 to 300 Kg
Pediatric 1 to 75 Kg
Neonate 0.1 to 16 Kg
Default: 1 Kg
63