Canon imageprograf ipf700 Service Manual page 64

Chapter 2
Cleaning
Name
mode
Cleaning 3
Initial filling ink
Ink drainage for head
Cleaning 4
replacement
Ink drainage for secondary
Cleaning 5
transport
Cleaning 6
Normal (strong) cleaning
Aging
Cleaning 7
Cleaning 8
Flushing
Cleaning 10
Ink filling after secondary
transport
Cleaning 15
Dot count suction
Cleaning 16
Precipitated ink agitation
Cleaning 17
Cleaning (weak)
2-18
Description of cleaning
Fills the empty tube (during initial installation) with
ink, and then performs normal cleaning.
Drains ink to replace the head (drains only the ink in
the head).
Drains ink from the head and tube for secondary
transport.
Performs suction stronger than when adjusting the ink
filling amount in the head or normal cleaning to unclog
nozzles.
Performs idle ejection after replacement of the head.
Performs idle ejection to remove burnt deposits on the
surface of the head heater.
Fills the empty tube (during installation after
secondary transport) with ink, and performs normal
cleaning.
Performs suction to remove ink adhered to dried
nozzles and thick ink accumulated on the face when
the dot count reaches the prescribed value.
Performs the agitation (ink supply valve open/close)
operation to prevent the ink ingredient from
precipitating.
Performs cleaning weaker than normal cleaning to
unclog nozzles.