Replacing A Raid Adapter Flash Power Module In The Standard I/O Book - IBM System x3850 X6 Installation And Service Manual

Replacing a RAID adapter flash power module in the standard I/O
book
Use this information for instructions on how to replace a RAID adapter flash
power module in the standard I/O book.
About this task
When you install RAID adapters that come with flash power modules in the
standard I/O book , install the flash power modules in the slots inside the
standard I/O book air baffle to prevent them from overheating. To install the flash
power modules in the air baffle, complete the following steps:
Procedure
1. Place the new flash power module into the flash power module slot in the air
2. Connect the flash power module cable to the adapter.
3. Close the air baffle cover. Rotate the cover down and press it until it is locked
4. Reinstall the standard I/O book (see "Replacing the standard I/O book" on
5. Reconnect the power cords and all external cables, and turn on the server and
260
System x3850 X6 and x3950 X6 Types 3837 and 3839: Installation and Service Guide
Air baffle
baffle.
in place.
page 222).
peripheral devices.
Standard I/O book