Table of Contents
Advertisement
Figure 63. Port connectors
Step 13. Reinstall the PCI riser-card assembly in PCI riser connector 1 if you have removed it previously (see
"Replacing a PCI riser-card assembly" on page
If you have other devices to install or remove, do so now. Otherwise, go to
page
100.
Installing a RAID adapter battery remotely in the server
Use this information to install a RAID adapter battery remotely in the server.
The batteries must be installed only on top of the microprocessor 2 air baffle. To install a RAID adapter
battery in the server, complete the following steps:
Step 1.
Read the safety information that begins on
41.
Step 2.
Turn off the server and peripheral devices and disconnect the power cords.
Step 3.
Remove the cover (see
Step 4
Note:
no RAID adapter is installed, skip to step
Step 4.
Remove the riser-card assembly from the server and set it aside (see
assembly" on page
Step 5.
Remove the adapter from the riser-card assembly.
Step 6.
If a battery and battery carrier are attached to the RAID adapter, disconnect the battery carrier
cable from the battery and remove the three screws that secure the battery carrier to the adapter.
Set the battery and battery carrier aside.
Note: If your battery and battery carrier are attached with a clip, squeeze the clip on the side of the
battery carrier to remove the battery from the battery carrier.
System x3550 M3Installation and User's Guide
84
"Removing the cover" on page
to
Step 5
apply to a RAID adapter that is already installed in the server riser-card. If
64).
64).
"Safety" on page iii
and
48).
Step 6 on page
84.
"Completing the installation" on
"Installation guidelines" on page
"Replacing a PCI riser-card
Advertisement
Table of Contents
