Gear Shift Position Sensor Check (Gps) - Husqvarna 2009 TE 310 Workshop Manual

Gear shift position sensor checking (GPS: Gear Position Sensor)
Set the tester on "Ohm" position then detach the 6 ways connector (1) from the
main wiring harness (the gear shift position sensor is fastened on the alternator
cable with a clamp). Ground a tester terminal on the engine then insert the other
one in the hole where is the gear sensor BLACK cable (2). The lever (3) is placed
on the left-hand side of the engine. After every shift, the lever automatically
returns to horizontal position. First gear is engaged by pushing the lever
downwards; all the other gears are engaged, by pushing the lever upwards. See
the table below for the data to be checked.
A NEUTRAL (open circuit)
B 1st gear
C 2nd gear
D 3rd gear
E 4th gear
F 5th gear
G 6th gear
Part. N. 8000 H0368 (09-2008)
ELECTRIC SYSTEM, DIGITAL INSTRUMENT
312÷319
556÷568 725÷739
817÷833 1,31÷1,34 K
1,48÷1,51 K 2,18÷2,23 K
2,71÷2,77 K 3,61÷3,68 K
6,75÷6,88 K 6,58÷6,71 K
14,8÷15,1 K 15,2÷15,5 K
TC-TXC TE-SMR
M.27
1
3