Chapter 6 Tutorials
Figure 50 Trunk Example
Set up the outgoing bandwidth on each of the WAN interfaces and configure the
WAN_TRUNK trunk's load balancing settings.
6.2.1 Set Up Available Bandwidth on Ethernet Interfaces
Here is how to set a limit on how much traffic the ZyWALL tries to send out through the three
WAN interfaces. This is especially important on ge2 and ge3 since they have less bandwidth.
1 Click Network > Interface > Ethernet and the ge2 Edit icon. Enter the available
bandwidth (1000 kbps) in the Egress Bandwidth field. Click OK.
Figure 51 Network > Interface > Ethernet > Edit (ge2)
2 Repeat the process to set the egress bandwidth for ge3 to (1000 kbps) and the egress
bandwidth for ge7 to (100000 kbps).
6.2.2 Configure the WAN Trunk
1 Click Network > Interface > Trunk. Click WAN_TRUNK's Edit icon.
2 In the Load Balancing Algorithm field, select Spillover. After the screen refreshes,
click the Add icon at the top of the right-hand column.
126
ge2: 1 Mbps
ge3: 1 Mbps
ge7: 100 Mbps
ZyWALL USG 300 User's Guide