The Static Dhcp Screen; The Ppp Interfaces Screen; Figure 124 Static Dhcp; Figure 125 Example: Pppoe/Pptp Interfaces - ZyXEL Communications ZyWALL USG 300 User Manual

Chapter 10 Interface

10.5 The Static DHCP Screen

In an interface add or edit screen, click Edit static DHCP table to open the Static DHCP
screen. Use this screen to configure the list of static IP addresses the ZyWALL assigns to
computers connected to the interface. If a computer's MAC address is in the interface's static
DHCP table, the ZyWALL assigns the corresponding IP address. Otherwise, the ZyWALL
assigns an IP address dynamically using the interface's IP Pool Start Address and Pool Size.
You must click OK in the Static DHCP screen and then click OK in the interface add or edit
screen to save your changes.

Figure 124 Static DHCP

The following table describes this screen.

Table 50 Static DHCP

LABEL
#
IP Address
MAC Address
Description
Add icon
OK
Cancel

10.6 The PPP Interfaces Screen

Use PPP interfaces (PPPoE/PPTP interfaces) to connect to your ISP so you do not have to
install or manage PPPoE or PPTP software on each computer in the network.

Figure 125 Example: PPPoE/PPTP Interfaces

194
DESCRIPTION
This field is a sequential value, and it is not associated with a specific entry.
Enter the IP address to assign to a device with this entry's MAC address.
Enter the MAC address to which to assign this entry's IP address.
Enter a description to help identify this static DHCP entry. You can use
alphanumeric and ()+/:=?!*#@$_%- characters, and it can be up to 60
characters long.
This column lets you create and remove static DHCP entries.
To add an entry, click the Add icon.
To remove an entry, click it's Remove icon.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL USG 300 User's Guide