The Http Redirect Edit Screen; Figure 191 Network > Http Redirect; Figure 192 Network > Http Redirect > Edit; Table 98 Network > Http Redirect - ZyXEL Communications ZyWALL USG 300 User Manual

You can configure up to one HTTP redirect rule for each (incoming) interface.
Figure 191 Network > HTTP Redirect
The following table describes the labels in this screen.
Table 98 Network > HTTP Redirect
LABEL
Name
Interface
Proxy Server
Port
Add icon
Apply
Reset

17.2.1 The HTTP Redirect Edit Screen

Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click the Add or
Edit icon to open the HTTP Redirect Edit screen where you can configure the rule.
Figure 192 Network > HTTP Redirect > Edit
ZyWALL USG 300 User's Guide
DESCRIPTION
This is the descriptive name (up to 31 printable characters) of a rule.
This is the interface on which the request must be received.
This is the IP address of the proxy server.
This is the service port number used by the proxy server.
Click the Add icon in the heading row to add a new entry.
The Active icon displays whether the rule is enabled or not. Click the Active icon to
activate or deactivate the rule. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the rule on the ZyWALL.
Click the Remove icon to delete an existing rule from the ZyWALL. A window
displays asking you to confirm that you want to delete the rule.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
Chapter 17 HTTP Redirect
297