Figure 329 Apppatrol > General; Table 137 Apppatrol > General - ZyXEL Communications ZyWALL USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWALL USG 300:

Table of Contents

Chapter 28 Application Patrol

Chapter 8 on page 165

Click AppPatrol to open the following screen.

Figure 329 AppPatrol > General

The following table describes the labels in this screen. See

more information as well.

Table 137 AppPatrol > General

Priority for

Registration

Registration

Registration

for how to register.

Select this check box to turn on application patrol.

This is a global setting for enabling or disabling bandwidth management on the

ZyWALL. You must enable this setting to have individual policy routes or

application patrol policies apply bandwidth management.

This same setting also appears in the Network > Routing > Policy Route screen.

Enabling or disabling it in one screen also enables or disables it in the other screen.

Select this to maximize the throughput of SIP traffic to improve SIP-based VoIP call

sound quality. This has the ZyWALL immediately send SIP traffic upon identifying

it. The ZyWALL ignores any other application patrol rules for SIP traffic (so there is

no bandwidth control for SIP traffic). When this option is enabled the ZyWALL also

does not record SIP traffic bandwidth usage statistics.

The following fields display information about the current state of your subscription

for IDP/application patrol signatures.

This field displays whether a service is activated (Licensed) or not (Not Licensed)

or expired (Expired).

This field displays whether you applied for a trial application (Trial) or registered a

service with your iCard's PIN number (Standard). None displays when the service

is not activated.

This link appears if you have not registered for the service or only have the trial

registration. Click this link to go to the screen where you can register for the

The following fields display information on the current signature set that the

ZyWALL is using.

Section 28.3.1 on page 434

ZyWALL USG 300 User's Guide

Troubleshooting