ZyXEL Communications ZyWALL USG 300 User Manual page 204

Chapter 10 Interface
Table 55 Interface > Cellular > Add (continued)
LABEL
Check Fail
Tolerance
Check Default
Gateway
Check this
address
Check Port
Related Setting
Configure
WAN TRUNK
Configure
Policy Route
More Settings/
Less Settings
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Device Settings
Device
Selection
Band Selection This field appears if you selected a 3G device that allows you to select the type of
OK
Cancel
204
DESCRIPTION
Enter the number of consecutive failures before the ZyWALL stops routing
through the gateway.
Select this to use the default gateway for the connectivity check.
Select this to specify a domain name or IP address for the connectivity check.
Enter that domain name or IP address in the field next to it.
This field only displays when you set the Check Method to tcp. Specify the port
number to use for a TCP connectivity check.
Click WAN TRUNK to go to a screen where you can configure the interface as
part of a WAN trunk for load balancing.
Click Policy Route to go to the screen where you can configure a policy route to
associate traffic with this interface.
Click this button to display a greater or lesser number of configuration fields.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Enter the cellular interface's WAN IP address in this field if you selected Use
Fixed IP Address.
Select the 3G card to use with this entry or select auto to have the ZyWALL
automatically detect the type of card.
network to use. Select the type of 3G service for your 3G connection. If you are
unsure what to select, check with your 3G service provider to find the 3G service
available to you in your region.
Select auto to have the card connect to an available network. Choose this option
if you do not know what networks are available.
You may want to manually specify the type of network to use if you are charged
differently for different types of network or you only have one type of network
available to you.
Select GPRS / EDGE (GSM) only to have this interface only use a 2.5G or 2.75G
network (respectively). If you only have a GSM network available to you, you may
want to select this so the ZyWALL does not spend time looking for a WCDMA
network.
Select UMTS / HSDPA (WCDMA) only to have this interface only use a 3G or
3.5G network (respectively). You may want to do this if you want to make sure the
interface does not use the GSM network.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL USG 300 User's Guide