Set Up Available Bandwidth On Ethernet Interfaces - ZyXEL Communications ZyWALL USG100-Plus User Manual

respectively. As these connections have different bandwidth, use the Weighted Round Robin
algorithm to send traffic to wan1 and wan2 (or cellular1) in a 2:1 ratio.
Figure 39 Trunk Example For Dual WANs
Figure 40 Trunk Example For WAN and 3G Interface
You do not have to change many of the ZyWALL's settings from the defaults to set up this trunk.
You only have to set up the outgoing bandwidth on each of the WAN interfaces and configure the
WAN_TRUNK trunk's load balancing settings.

5.2.1 Set Up Available Bandwidth on Ethernet Interfaces

Here is how to set a limit on how much traffic the ZyWALL tries to send out through each WAN
interface.
Click Configuration > Network > Interface > Ethernet and double-click the wan1 entry. Enter
1
the available bandwidth (1000 kbps) in the Egress Bandwidth field. Click OK.
ZyWALL USG100-PLUS User's Guide
wan1: 1 Mbps
wan2: 512 Kbps
wan1: 1 Mbps
cellular1: 512 Kbps
Chapter 5 Managing Traffic
101