ZyXEL Communications ZyWALL USG 300 User Manual page 796

Appendix A Log Descriptions
Table 298 Interface Logs (continued)
LOG MESSAGE
Interface %s is
disconnected.
Interface %s connect
failed: Peer not
responding.
Interface %s connect
failed: PAP
authentication
failed.
Interface %s connect
failed: Connect
timeout.
Interface %s create
failed because has no
member.
"Interface cellular
Application Error Code
%d\n.
"An error [%d]
occurred while
negotiating with the
device in %s. Please
try to remove then
insert the device.
"Unable to negotiate
with the device in %s.
Please try to remove
then insert the
device.
"Unable to configure
the selected frequency
band to the device in
%s. Please try to
remove then insert the
device.
"PIN code is required
for inteface
cellular%d. Please
check the PIN code
setting.
"SIM card has been
successfully unlocked
by PUK code on
interface cellular%d.
"Incorrect PUK code of
interface cellular%d.
Please check the PUK
code setting.
796
DESCRIPTION
A PPP or AUX interface disconnected successfully. %s: interface
name.
The interface's connection will be terminated because the server did
not send any LCP packets. %s: interface name.
PAP authentication failed (the server must support PAP and verify
verify that the authentication failed, this does not include cases where
the server does not support PAP). %s: PPP interface name.
A PPPOE connection timed out due to a lack of response from the
PPPOE server. %s: PPP interface name.
A bridge interface has no member. %s: bridge interface name.
The listed error code (%d) was generated due to an internal cellular
interface error.
The listed error code (%d) happened when the ZyWALL attempted to
negotiate with the cellular device installed in (or connected to) the
listed slot (%s). Remove and reinstall the device.
The ZyWALL could not negotiate with the cellular device installed in (or
connected to) the listed slot (%s). Remove and reinstall the device.
The ZyWALL failed to set the cellular device installed in (or connected
to) the listed slot (%s) to use the frequency band you configured. The
cellular device may not support the band or you may need to try
removing and reinstalling the device.
The PIN code configured for the listed cellular interface (%d) is
incorrect or missing.
You entered the correct PUK code and unlocked the SIM card for the
cellular device associated with the listed cellular interface (%d).
You entered an incorrect PUK code so you were not able to unlock the
SIM card for the cellular device associated with the listed cellular
interface (%d).
ZyWALL USG 300 User's Guide