Force User Authentication Policy Add/Edit Screen; Figure 412 Object > User/Group > Setting > Add/Edit - ZyXEL Communications ZyWALL USG 300 User Manual

Unified security gateway

Hide thumbs Also See for ZyWALL USG 300:

Table of Contents

Chapter 36 User/Group

Table 196 Object > User/Group > Setting (continued)

Authenticate

36.4.1 Force User Authentication Policy Add/Edit Screen

Use this screen to specify a condition when users must log in or do not have to log in to the

ZyWALL before their HTTP traffic can pass through the ZyWALL.

Figure 412 Object > User/Group > Setting > Add/Edit

This field displays the source address object of traffic to which this condition

applies. It displays any if this condition applies to traffic from all source

This field displays the destination address object of traffic to which this

condition applies. It displays any if this condition applies to traffic from all

destination addresses.

This field displays whether users must log in (force) or whether users do not

have to log in (skip) when this condition is checked and satisfied.

This column provides icons to add, edit, move, and remove conditions. It also

provides icons to activate and deactivate conditions.

To add a condition, click the Add icon at the top of the column or next to each

condition. If you click the one at the top of the column, the new condition is first

in the list. If you click the one next to a condition, the new condition appears

right below this condition.

To edit a condition, click the Edit icon at the top of the column or next to each

condition. The Force User Authentication Policy Add/Edit screen appears.

To remove a condition, click on the Remove icon next to the condition. The

Web Configurator confirms that you want to delete the condition before doing

To move a condition up or down in the list, click on the Move to N icon next to

the condition, and type the line number (# field) where you want to move this

condition. The # field is updated accordingly.

To activate or deactivate a condition, click the Active icon next to the

condition. Make sure you click Apply to save and apply the change.

Click Apply to save the changes.

Click Reset to start configuring this screen again.

ZyWALL USG 300 User's Guide