ZyXEL Communications ZyWALL USG 300 User Manual page 69

Table 6 Navigation Panel Summary (continued)
LINK TAB
Interface Status
Port Grouping
Ethernet
PPPoE/PPTP
Cellular
WLAN
VLAN
Bridge
Auxiliary
Trunk
Routing Policy Route
Static Route
RIP
OSPF
Zone
DDNS Profile
Status
Virtual
Server
HTTP
Redirect
ALG
IP/MAC Summary
Binding
Exempt List
Monitor
Firewall Firewall
Session Limit
VPN
IPSec VPN VPN Connection
VPN Gateway
Concentrator
SA Monitor
ZyWALL USG 300 User's Guide
FUNCTION
Use this screen to see information about all of the ZyWALL's interfaces and
their connection status.
Use this screen to configure physical port groups.
Use this screen to manage Ethernet interfaces and virtual Ethernet
interfaces.
Use this screen to create and manage PPPoE and PPTP interfaces.
Use this screen to configure settings for a cellular Internet connection through
an installed 3G card.
Use this screen to configure settings for an installed wireless LAN card.
Use this screen to create and manage VLAN interfaces and virtual VLAN
interfaces.
Use this screen to create and manage bridges and virtual bridge interfaces.
Use this screen to manage the AUX port.
Use this screen to create and manage trunks for load balancing and link HA.
Use this screen to create and manage routing policies.
Use this screen to create and manage IP static routing information.
Use this screen to configure device-level RIP settings.
Use this screen to configure device-level OSPF settings, including areas and
virtual links.
Use this screen to configure zones used to define various policies.
Use this screen to define and manage the ZyWALL's DDNS domain names.
Use this screen to view the status of the ZyWALL's DDNS domain names.
Use this screen to set up and manage port forwarding rules.
Use this screen to set up and manage HTTP redirection rules.
Use this screen to configure SIP, H.323, and FTP pass-through settings.
Use this screen to configure IP to MAC address bindings for devices
connected to each supported interface.
Use this screen to configure ranges of IP addresses to which the ZyWALL
does not apply IP/MAC binding.
Use this screen to display the devices that have received an IP address from
ZyWALL interfaces with IP/MAC binding enabled.
Use this screen to create and manage level-3 traffic rules.
Use this screen to limit the number of concurrent NAT/firewall sessions a
client can use.
Use this screen to configure IPSec tunnels.
Use this screen to configure IKE tunnels.
Use this screen to configure VPN concentrators (hub-and-spoke VPN).
Use this screen to monitor current IPSec VPN tunnels.
Chapter 3 Web Configurator
69