Figure 2 Managing the ZyWALL: Web Configurator
Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the ZyWALL. You can access it
using remote management (for example, SSH or Telnet) or via the console port. See the
Command Reference Guide for more information about the CLI.
Console Port
You can use the console port to manage the ZyWALL using CLI commands. See the
Command Reference Guide for more information about the CLI.
The default settings for the console port are as follows.
Table 2 Console Port Default Settings
SETTING
Speed
Data Bits
Parity
Stop Bit
Flow Control
1.4 Starting and Stopping the ZyWALL
Here are some of the ways to start and stop the ZyWALL.
Table 3 Starting and Stopping the ZyWALL
METHOD
Turning on the power
Rebooting the
ZyWALL
Using the RESET
button
ZyWALL USG 300 User's Guide
VALUE
115200 bps
8
None
1
Off
DESCRIPTION
A cold start occurs when you turn on the power to the ZyWALL. The ZyWALL
powers up, checks the hardware, and starts the system processes.
A warm start (without powering down and powering up again) occurs when
you use the Reboot button in the Reboot screen or when you use the
reboot
command. The ZyWALL writes all cached data to the local storage,
stops the system processes, and then does a warm start.
If you press the RESET button, the ZyWALL sets the configuration to its
default values and then reboots.
Chapter 1 Introducing the ZyWALL
55