Figure 35 Vpn Express Wizard: Step 3 - ZyXEL Communications ZyWALL USG 300 User Manual

Chapter 4 Wizard Setup

Figure 35 VPN Express Wizard: Step 3

The following table describes the labels in this screen.
Table 16 VPN Express Wizard: Step 3
LABEL
Secure
Gateway
Pre-Shared
Key
Local Policy
(IP/Mask)
Remote Policy
(IP/Mask)
96
DESCRIPTION
If Any displays in this field, it is not configurable for the chosen scenario.
If this field is configurable, enter the WAN IP address or domain name of the remote
IPSec router (secure gateway) to identify the remote IPSec router by its IP address
or a domain name.
Type your pre-shared key in this field. A pre-shared key identifies a communicating
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with "0x".
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.
Type a static local IP address that corresponds to the remote IPSec router's
configured remote IP address (the remote IP address of the other ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind your ZyWALL.
If Any displays in this field, it is not configurable for the chosen scenario.
If this field is configurable, type a static local IP address that corresponds to the
remote IPSec router's configured local IP address (the local IP address of the other
ZyWALL).
To specify IP addresses on a network by their subnet mask, type the subnet mask of
the LAN behind the remote gateway.
ZyWALL USG 300 User's Guide