The Application Patrol Policy Edit Screen; Figure 332 Application Policy Edit; Table 140 Application Policy Edit - ZyXEL Communications ZyWALL USG 300 User Manual

Chapter 28 Application Patrol
Table 139 Application Edit (continued)
LABEL
Add icon
OK
Cancel

28.3.2 The Application Patrol Policy Edit Screen

The Application Policy Edit screen allows you to edit a group of settings for an application.
To access this screen, go to the application patrol Common, Instant Messenger, Peer to
Peer, VoIP, or Streaming screen and click an application's Edit icon. Then click the Add
icon or an Edit icon in the Policy table. The screen displayed here is for the MSN instant
messenger service.

Figure 332 Application Policy Edit

The following table describes the labels in this screen.

Table 140 Application Policy Edit

LABEL
Enable Policy
Port
Schedule
436
DESCRIPTION
Click the Add icon in the heading row to add a new first entry.
The Active icon displays whether the entry is enabled or not. Click the Active icon
to activate or deactivate the entry. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the entry.
Click the Add icon in an entry to add a new entry below the current entry.
Click the Remove icon to delete an existing entry from the ZyWALL. A window
displays asking you to confirm that you want to delete the entry.
To move an entry up or down in the list, click on the Move to N icon next to the
entry, and type the line number (# field) of where you want to move the entry. The #
field is updated accordingly. The ordering of the entries is important as they are
applied in order of their numbering.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
DESCRIPTION
Select this check box to turn on this policy for the application.
Use this field to specify a specific port number to which to apply this policy. Type
zero, if this policy applies for every port number.
Select a schedule that defines when the policy applies or select Create Object to
configure a new one (see Chapter 39 on page 601
none to make the policy always effective.
for details). Otherwise, select
ZyWALL USG 300 User's Guide