Set Up Available Bandwidth On Ethernet Interfaces - ZyXEL Communications ZyWall USG 2000 User Manual

You do not have to change many of the ZyWALL's settings from the defaults to set
up this trunk. You only have to set up the outgoing bandwidth on each of the WAN
interfaces and configure the WAN_TRUNK trunk's load balancing settings.

7.3.1 Set Up Available Bandwidth on Ethernet Interfaces

Here is how to set a limit on how much traffic the ZyWALL tries to send out
through each WAN interface.
Click Configuration > Network > Interface > Ethernet and double-click the
1
ge2 entry. Enter the available bandwidth (1000 kbps) in the Egress Bandwidth
field. Click OK.
Figure 77 Configuration > Network > Interface > Ethernet > Edit (ge2)
Repeat the process to set the egress bandwidth for ge3 to (512 Kbps).
2
ZyWALL USG 2000 User's Guide
Chapter 7 Tutorials
127