Adjusting The Print Start Timing - Kyocera TASKalfa 300i Service Manual

2K5
Maintenance
item No.

Adjusting the print start timing

U034
Description
Adjusts the leading edge registration or center line.
Purpose
Make the adjustment if there is a regular error between the leading edges of the copy image and original.
Make the adjustment if there is a regular error between the center lines of the copy image and original.
Method
1. Press the start key.
2. Select the item to be adjusted. The setting screen for the selected item is displayed.
Display
LSU OUT TOP
LSU OUT LEFT
Adjustment: Leading edge registration adjustment
1. Select the item to be adjusted.
Display
LSUOUT TOP
MPT (L)
LSUOUT TOP
CAS (L)
LSUOUT TOP
DUP (L)
LSUOUT TOP
MPT (S)
LSUOUT TOP
CAS (S)
LSUOUT TOP
DUP (S)
Large size: 218 mm or more in width of paper.
2. Press the system menu key.
3. Press the start key to output a test pattern.
4. Press the system menu key.
5. Change the setting value using the +/- or numeric keys.
For output example 1, increase the value. For output example 2, decrease the value.
Leading edge
registration
(20 ± 1.0 mm)
6. Press the start key. The value is set.
Remark
When changing the setting value of [Large] each item is modified, equal to amount of the value which is
changed adds also the value of [Small] each item and is pulled.
1-3-22
Description
Description
Leading edge registration adjustment
Center line adjustment
Description
Paper feed from MP tray
(when large size paper is used)
Paper feed from cassette
(when large size paper is used)
Duplex mode (second)
(when large size paper is used)
Paper feed from MP tray
(when small size paper is used)
Paper feed from cassette
(when small size paper is used)
Duplex mode (second)
(when small size paper is used)
Correct image
example 1
Figure 1-3-4
Setting
range
-10.0 to
30.0
-10.0 to
30.0
-10.0 to
30.0
-10.0 to
30.0
-10.0 to
30.0
-10.0 to
30.0
Output Output
example 2
Initial Change in
setting value per step
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm