Starter Relay And Side-Stand/Ignition Interlock Relay (Dr350Ser); Starter Relay Inspection (Dr350Ser); Side-Stand Switch Inspection (Dr350Ser); Side-Stand/Ignition Interlock Relay Inspection (Dr350Ser) - Suzuki DR350 Service Manual

13·35 DR35DRISER ('94-MDDElI
STARTER RELAY AND SIDE-ST AND/IGNITION INTERLOCK RELAY
(DR350SER)
STARTER RELAY INSPECTION
• Disconnect the lead wire of starter motor at starter relay .
• Turn on the ignition switch, inspect the continuity between
the terminals. positive and negative. when squeezing the
clutch lever and pushing the starter button .
If the starter relay is in sound condition. continuity if found .
09900-25002: Pocket tester
• Disconnect the lead wires from the starter relay .
• Check the coil for "open". "ground " and ohmic resistance .
The coil is in good condition
if
the resistance is as follows .
Starter relay resistance: 3 - 7
n
09 900·2 5002 : Pocket test' a r
SIDE-STAND SWITCH INSPECTION
Green BlacklWhite
ON
0-
-0
(Up-right position)
I
OFF
(Down position)
SIDE-STAND/IGNITION INTERLOCK RELAY
INSPECTION
Disconnect the side-standlignition interlock relay .
First, check the insulation between
CD
and
®
terminals w ith
pocket tester. Then apply 12 volts to
@
and
@
terminals .
@ to
@
and
e
to
@,
and check the continuity between
CD
and @.
If there is no continuity. replace it with a new one .
09900· 25002: Pocket tester
NOTE:
When inspecting side-stand switch.
connect the
<±)
probe of pocket tester
to Black./White lead wire and
e
probe
to Green lead wire.