Cam Chain Tensioner Adjuster - Suzuki DR350 Service Manual

NOTE:
00
not apply SUZUKI80ND No. 1207811215
(0
(he cam ·
shaft end cap.
• Install the dowel pins.
• Fit the four new gaskets
CD
to the head cover bolts cor-
rectlv_
CAUTION:
Use new gaskets to prevent oil leakage.
NOTE:
When tightening the cylinder head cover bolts, the piston
must be at top dead center on the compression s troke.
• Lightly tighten the cylinder head cover bolts sequential+
IV in the ascending order of numbers, and then
if
every·
thing is satisfactory . tighten securely with a torque
wrench to the specified torque .
Tightening torque : 8 - 12 N -m
10.8 - 1 .2 kg · m. 6 .0 - 8 .5 Ib·lt)
CAM CHAIN TENS lONER ADJUSTER
Install the cam chain tensioner adjuster following the proce-
dure be low .
• Apply SUZUKI MOLY PASTE to the push rod
@.
99000· 25140: SUZUKI MOLY PASTe
• Unlock the ratchet mechanism
@
and push in the push
rod @ al1 the way before mounting th e chain ten sioner.
• Install a new gasket and the cam chain tensioner to the
cylinder block with two bolts
(@)
and @ L and tighten
them to the specified torque as shown in the illustration .
Tightening torque :
801t
@) :
8-12 N 'm 10 .8 - 1.2 kg·m. 6 .0 - 8.5 Ib·lt}
Bolt ® : 9 - 13 N'm 10.9 - 1.3 kg·m. 6 .5 - 9 .5Ib·lt}
CAUTION:
Always use a new gasket and O-ring
®
to prevent oil
leakage.
ENGINE 3-46