Throttle Cable Adjustment (Dr350Sn) (Except For Australia); Standard Suspension Setting (Dr350Sn) - Suzuki DR350 Service Manual

11·19 OR350NIOR350SN 1'92·MOOELI
THROTTlE CABLE ADJUSTMENT (DR350SN)
(Except for Australia)
A
twin
t hrottle cable system is used in this motorcycle. Cable
ill
is for pulling and cable @ is for returning . To adjust the cable
play . adjust the returning cable first and then adjust the
pull ing cable.
Return ing Cable Play
The returning cable adjuster
®
should have 2 - 3 mm (0.08 -
0 .12
in ) of
clearance as shown in the illustration. If the adjust-
ment is necessary, carry out the procedure below :
• Loosen the lock nut
@.
• Move the adjuster @ toobta in the clearance
(6.
of 2 - 3 mm
10.08 - 0.12 ;nl.
• Tighten the lock nut @ securely.
Pulling Cable Play
The pulling cable play @ should be 0 .5 - 1.0 mm (0.02 -
0.04
in) ,
If the adjustment is necessary, carry out the procedure
below:
• Turn the handlebar all the way to the left.
• Loosen lock nuts (®,
@l.
• Turn adjuster
ill
or move the adjuster
@
to obtai n a cable
play of 0 .5 - i .O mm (0 .02 - 0 .04 in) .
• Tighten lock nuts (®,
® )
securely.
WARNING :
After the adjustment is completed, check that handlebar
movement does not raise the engine idle speed and that the
throttle grip returns smoothly and automatically .
STANDARD SUSPENSION SETTING
FRONT
Spring pre· load adjuster
Damping force adjuster Spri ng set length
REAR
3
Max. - 8
268.2 mm (10. 56 ;nl
Damping force adjuster
Max . - 3/4