Crankcase - Suzuki DR350 Service Manual

CRANKCASE
When reassembling the crankcase pay attention to the fol-
lowing points:
• Remove sealant material on the mating surfaces of right
and left halves of crankcase and thoroughly remove oil
stains .
• Fit the new O-ring
G)
and dowel pins
@
on the left half
as shown in Fig ,
• Apply engine oil to the conrad big end of the c rankshaft
and all parts of the transmission gears.
• Apply SUZUKI BOND No. 12078/ 1215 uniformly to the
mating surface of the right and left crankcases as shown
in the illustration, and assemble the cases within few
minutes .
99104· 31140 : SUZUKI BONO No. 1207B IU .S .A .)
99000·31110 : SUZUKI BONO NO .1 21 5 IOthe,s)
left c ra nkcase
• Tighten the crankcase bolts to the specified torque.
Tightening torque : 9 - 13 N'm
10.9-1 .3 kg·m. 6.5 - 9.5Ib·ft)
• After the c rankcase bolts have been tightened. check if
crankshaft. countershaft and drives haft rotate smoothly .
• If a large resistance is felt to rotation . try to free the shafts
by tapping the shahs with a plasti c hammer.
ENGINE J·J6
Right crank case
00
00