Clutch Drive Plate; Clutch Driven Plate; Clutch Spring Free Length; Clutch Release Bearing - Suzuki DR350 Service Manual

3·27 ENGINE
CLUTCH DRIVE PLATE
Measure the thickness and claw width of each drive plate
with vernier calipers. Replace drive plates found to have
worn down to the limit.
Standard Service Limit
2.72 - 2 .88 mm
2.42 mm
Thickness
10.107-0.113 inl
10.095 inl
Claw width
15.8 - 16.0 mm
15.2 mm
10.62-0.63 inl
10.60 inl
0 9 9 00-20 101 : V ernier calipers
CLUTCH DRIVEN PALTE
Measure each driven plate for distortion with a thic kness
gauge.
Replace driven plates which exceed the limit.
Se rvice limit : 0 .10 mm (0 .004 in )
09900 -20803 : Thickness gauge
CLUTCH SPRING FREE LENGTH
Measure the free length of each coi l spring with a vernier
calipers, and determine the elastic strength of each. Replalce
any spring not within the limit.
Service Limit : 29 .5 m m 11.1 6 in )
0 99 00·2010 1 : Ve rnie r calipe rs
CLUTCH RElEASE BEARING
In spect the release bearing for any abnormality. particular-
ly c racks. to decide whether it ca n be reused or should be
repla ced . Smooth engagement and disengagement of the
clu tch depends much on the condition of this bearing .
,
Measuring thickne ss
M easuring claw width
Measuring distortion
Measuring c lutch spring