Rear Swingarm And Suspension Reassembly And Remounting; Shock Absorber Spring Pre-Load Adjustment - Suzuki DR350 Service Manual

REASSEMBLY AND REMOUTING
Reassemble and remount the rear suspension in the reverse
order o f remova l and disasse mbl y. and also carry out the
foll owing steps .
• Reassem ble and rem ount the fea f suspensio n. (Refer to
pages 6 -2B. and 6-33.1
• Install the cushion lever and swing arm bearings with the
special tool and proper socket w rench .
09924·84510 : Bearing installer
NOTE:
When ins talling the bearing, th e s tamped mark on the bear-
ing ;s positioned outside.
SHOCK ABSORBER SPRING PRE-LOAD
ADJUSTMENT
Using the universal c lamp w rench, adjust the spring tension
o f the shock absorber by turning the spring pre-load adjust er
ring as follows .
Standard spring pre-set length : 269.2 mm 110 .6 inl
09910 -60611 : Universal clamp wrench
CAUTION :
After adjusting the pre-load. tighten the spring adjuster lock
ring sec urely .
SETTING TABLE
Spring length
STO :
269.2 mm 110.6
inl
Softer: 274 .2
mm
(10 .8 in)
Stiffer: 261.2
mm
(10.3 in)
Damping force adjuster (STD)
Compression: Max . - 2
Rebound ; Max . - 2 .5
CHASSIS 6·32