Rear Wheel Inspection And Disassembly; Wheel Hub Bearing; Rear Sprocket; Rear Wheel Reassembly And Remounting - Suzuki DR350 Service Manual

6·21 CHASSIS
INSPECTION AND DISASSEMBLY
WHEEL HUB BEARING
Inspect the play of the wheel hub bearings by hand whi le
mounted in the wheel hub.
Rotate the inner ring by hand to inspect if any abnormal noise
occurs or rotating smoothly.
Replace the bearing if there is anything unusual.
• Remove the bo th bearings with a appropriate bar .
CAUTION:
The removed bearing should be replaced with new ones .
•
REAR SPROCKET
In spect the sprocket teeth for wear. If they are worn as il-
lu strated, repla ce the sprocket and drive chain.
AXLE SHAFT . ...•.•. . .... •...
WHEEL RIM . . . . . . . . .... . .... .
TI R E . . . . . . . . . . . . . . . . . . . . . . . .
Service limit : 4 .0 mm 10.16 inl
SPOKE NiPPLE . . ... • .... ..• .. •
Refer to page 6 ·2.
Refer to page 6 -2 .
Refer to page 2-13
Refer to page 6 -3 .
REASSEMBLY AND REMOUNTING
• Reassemble and remoun t the rear wheel in the reverse
order o f removal· and disassembly, and also carry out the
following steps:
• Reassemble and remount the rear wheel. (Refer to page
6 -20 .)
Play
Play
--'-
--
- . _. -
Normal wear Excessive w ear