Adjust Mode; Adjust Mode Menu Screen; Adjust Mode Function Setting Procedure - Minolta Di350 Service Manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
7

ADJUST MODE

• Adjust mode is for adjustments to be made before shipment at the factory. As a rule, use
this mode only when MFB Board UN2, or EEPROM (IC3A) on Master Board PWB-A has
been replaced with a new one.
7-1.

Adjust Mode Menu Screen

7-2.

Adjust Mode Function Setting Procedure

<Setting Procedure>
1. Set the copier into the Tech. Rep. mode by the following method:
• With the Meter Count screen opened from Utility, press the following keys in this order.
Stop Key
2. Enter the Adjust mode by pressing the following keys in this order:
Stop Key
3. Select the particular Adjust mode function to be set.
4. Make the necessary settings by following the instructions given sequentially on the
screen.
The function selected is highlighted.
<Exiting the Mode>
Perform any one of the following steps to go back to the Basic screen.
• Press the Panel Reset key and Touch [Exit] on the Tech. Rep. Mode screen.
• Touch [END] on the Adjust mode screen. Then touch [Exit] on the Tech. Rep. Mode
screen.
0
Start Key
0 Stop Key
S-39
1167S012CA
0 1