Loop Adjustment - Minolta Di350 Service Manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09

(3) Loop Adjustment

Requirement
Adjust so that a correct loop is formed before the Synchronizing Rollers when paper is fed
through.
Adjust Mode Setting Value
Loop Adjustment -5 to +5
NOTE
This adjustment is to be made when any of the following symptoms occurs: variations in the
amount of print leading edge void, paper skew, and misfeed.
Adjustment Procedure
1. Call the Tech. Rep. mode to the screen.
2. Touch [Tech. Rep. Choice], then [Printer].
3. Touch [Loop Adjustment] to enter the Loop Adjustment mode.
4. Select the paper source for which the adjustment is to be made.
5. Press the Clear key to clear the current setting.
6. Enter the new setting value from the 10-Key Pad.
Setting Instructions
Change the setting value as necessary until there are no variations in the amount of void
image along the leading edge, skewed feeding, dog-ear, or misfeed.
Use to change the + or - sign.
Use to clear setting value.
1171D030CA Setting Value
Use to enter setting value.
1171D061CA
Use to change the + or - sign.
7. Touch the [END] key to validate the setting value.
Caution
Be sure to touch the END key before returning to normal operation mode. If the Panel
Reset Key is used, the previous setting remains valid.
8. Perform the same steps to adjust for the other paper sources.
D-34