Minolta Di350 Service Manual page 196

FrameMaker Ver.5.5E(PC) Di350 TROUBLESHOOTING
98.12.09
If a communications error occurs between UN2 and PWB-A during a copy cycle, it forces
a paper misfeed condition (
circuit between UN2 and PWB-A for proper connection and, if it is intact, replace the
board.
<Resetting the Display>
Misfeed in the copier
Remove all sheets of paper misfed and left
inside, and then open and close the Side
Cover.
If the misfeed display is not reset by these procedures, check the misfeed detecting sen-
sor at the paper location.
displayed on the Touch Panel). If that happens, check the
Remove all sheets of paper misfed and left
inside, and then raise and lower or discon-
nect and reconnect the option.
T-9
Misfeed in the option