Zoom Adjust (Ir - Minolta Di350 Service Manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09

(8) Zoom Adjust (IR)

1. CD
Requirement
1. The difference should be within ±1.0% of the actual length.
2. Adjust so that the following specifications are satisfied with a scale length of 300 mm.
Zoom Ratio
Full size (×1.000)
NOTE
This adjustment must be made when the Scanner Drive Cables have been replaced and
after the adjustments of Registration (CD and FD) (Printer) have been made.
Adjustment Procedure
Specification
300 ±3.0 mm
1. Place a scale in parallel with the Original Width
Scale and make a copy. (Note that the scale is per-
pendicular to the Original Length Scale.)
Use the full size (×1.000) mode and A3 or 11" × 17"
paper.
If the scale is of plastic and transparent, place a
blank sheet of paper over it.
1167D111AA
2. Measure the length of the scale on the copy to find
the difference.
If the difference is outside the specification, adjust
by following the procedure shown below.
1138D154AA
D-46
Adjust Mode
Zoom Adjust (CD)
Setting Range
0.990 to 1.010