Settings In The Tech. Rep. Mode; Tech. Rep. Choice - Minolta Di350 Service Manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25
5-4.

Settings in the Tech. Rep. Mode

(1) Tech. Rep. Choice

• This function allows the Tech. Rep. to make the various settings and adjustments.
<Function>
1. System Set
2. Printer
3. ADFR
4. Scan-through ADF
<Setting Procedure>
1. Touch [Tech. Rep. Choice] to open a screen to Tech. Rep. Choice.
2. Touch the desired major category key.
3. Touch the desired sub-category key.
<System Set>
Touch Panel
Display
Auto Paper Con-
figuration
FLS Paper
Simplex/Duplex
Tech. Rep. Mode
Setting (The default is
<Metric Areas>
Select either "Inch/Metric" or "Metric" for rounding off the original size
detected.
Inch / Metric
Metric
<Inch Areas>
Select either "Inch/Metric" or "Inch" for rounding off the original size
detected.
Inch / Metric
Inch
Set the size for FLS.
F: 330 mm
C: 203 mm
Select whether or not to enable the setting of 1-Sided
under Original Copy Default available from User's Choice.
If "Simplex & Duplex" is selected, 1-Sided
available as an option.
Display
Simplex & Duplex
Description Does not limit the options for
Original
2-sided copying only.
Tech. Rep. Choice
The measurement is rounded to the
nearest standard inch or metric size.
The measurement is rounded to the
nearest standard metric size.
The measurement is rounded to the
nearest standard inch or metric size.
The measurement is rounded to the
nearest standard inch size.
F: 330 mm
F: 330mm
C: 216 mm
C: 210mm
Copy Default to
S-18
).
Highlighted
F: 330 mm
C: 220 mm
1-Sided becomes
Duplex Only
Limits the options for
Original Copy Default
to 2-sided copying only.
1-Sided