Function - Minolta Di350 Service Manual

FrameMaker Ver.5.5(PC) Di350 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.11.25

(5) Function

• This function allows the Tech. Rep. to run the various function tests and make adjust-
ments.
<Setting Procedure>
1. Touch [Function] to open the Function menu screen.
2. Select the particular function to be run.
Touch Panel
Display
F1
F2
F7-1
F8
Tech. Rep. Mode
A paper passage test is carried out after the copier has completed
warming up.
<Procedure>
1. Select the paper source key. (Touch [Duplex] to check for paper
passage from the Duplex Unit.)
If the paper source is not loaded with paper, an Add Paper mark
appears at that source.
2. Press the Start key to start the test cycle. The test runs until the
paper source runs out of paper.
3. If the Stop key is pressed, the copier feeds the current sheet of
paper out before halting. (Another press of the Start key will
resume the test cycle.)
Set the output of each HV.
This function is only for factory setting and should never be used in
the field.
<Original Size Detecting Sensor Adjustment>
Automatically adjusts the Original Size Detecting Sensors.
<Procedure>
1. Stack five sheets of A3 or 11" × 17" paper on the Original Glass
and lower the Original Cover.
2. Press the Start key to let the system start the adjustment
sequence.
The system automatically stops as soon as the adjustment
sequence is completed. It can nonetheless be halted in mid-
sequence with the Stop key, which, however, results in incorrect
size detection as the adjustment sequence is incomplete.
<ATDC Sensor Automatic Adjustment>
Automatically makes the ATDC Sensor adjustment.
<Procedure>
Press the Start key to let the system start the adjustment sequence.
The voltage automatically adjusted by this function is displayed for
ATDC Sensor Gain of the Level History data.
Function
Operation
<Paper Passage>
<HV Output Setting>
S-28