Ir-Erasure Width - Minolta Di350 Service Manual

FrameMaker Ver.5.5E(PC) Di350 DIS/REASSEMBLY, ADJUSTMENT
98.12.09

(9) IR-Erasure Width

Requirement
A
A
NOTE
This adjustment must be made when a shadow is produced from the Original Scale.
Adjustment Procedure
1. Call the Tech. Rep. mode to the screen.
2. Touch [Tech. Rep. Choice].
3. Touch [IR-Erasure Width] to enter the IR-Erasure Width mode.
4. Press the Clear key to clear the current setting.
5. Enter the new setting value from the 10-Key Pad.
Setting Instructions
To make the erase width along four edges of the paper smaller, decrease the setting value.
To make the erase width along four edges of the paper greater, increase the setting value.
Setting Value
6. Touch the [END] key to validate the setting value.
Caution
Be sure to touch the END key before returning to normal operation mode. If the Panel
Reset Key is used, the previous setting remains valid.
Set so that the erase width along four edges of the
paper falls within the range of 0 to 3 mm.
A
IR-Erasure Width
A
1171D062AA
1171D064CA
D-50
Adjust Mode
Use to clear setting value.
Use to enter setting value.
Setting Range
0 to 3
1167D069AA