Inspect The Tires, Wheels And Lug Nut Torque - Genie ZX-135/70 Service Manual

Service Manual
Checklist B Procedures
2 Be sure the free-wheel valve on the drive
pump is closed (clockwise).
Note: The free-wheel valve should always remain
closed.
1 drive pump
2 screwdriver
3 lift pump
4 free-wheel valve
38
B-8
Inspect the Tires, Wheels and
Lug Nut Torque
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the tires and wheels, including proper
wheel fastener torque, is essential to safe
operation and good performance. Tire and/or
wheel failure could result in a machine tip-over.
Component damage may also result if problems
are not discovered and repaired in a timely
fashion.
Note: The tires on this machine are foam filled and
do not need air added to them.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracked welds.
3 Check each lug nut for proper torque. Refer to
Specifications, Machine Specifications.
ZX-135/70
August 2014
Part No. 218700