Genie ZX-135/70 Service Manual page 114

August 2014
How to Adjust the Function
Speeds
Note: Perform this procedure with the boom in the
stowed position.
Note: Use the following chart to identify the
description of each LCD screen control button
used in this procedure.
Plus Minus
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
Press and hold the enter button on the
2
ground control panel while turning the key
switch to platform controls. Hold the enter
button for approximately 5 seconds.
3 Press the plus button twice, then press the
minus button twice.
4 Press the previous button until the function to
be adjusted is displayed.
Press the plus button to increase the speed
5
or press the minus button to decrease the
speed.
Part No. 218700
Previous Enter
ZX-135/70
Platform Controls
6 Press the enter button to save the setting in
memory.
7 Press the enter or previous button on the
LCD screen until EXIT is displayed.
Press the plus button or minus button to
8
select YES and then press the enter button.
9 Continue to perform this procedure until the
machine function speed meets specification.
Refer to the specifications, Performance
Specifications.
Service Manual
99