August - Genie ZX-135/70 Service Manual

August 2014

7 Enter sensor calibration mode by pressing the
buttons at the ground controls in the following
sequence: (plus)(enter)(enter)(plus).
Press the enter or previous button on the
8
LCD screen until DELETE AXLE ANGLE
SENSORS CALIBRATION is displayed.Press
the plus button to select YES, then press the
enter button to accept.
9 At the ANGLES FULLY RETRACTED
AXLE
screen, press the plus button to select YES,
then press the enter button to accept.
10 When the AXLE ANGLES FULLY
EXTENDED screen is displayed, start the
engine and fully extend the axles.
Note: If the system exits out of calibration mode
when the engine is started, repeat step 10.
11 Press the plus button to select YES, then
press the enter button to accept.
12 Press the enter or previous button on the
LCD screen until EXIT is displayed.
13 Press the plus button to select YES, then
press the enter button to accept.
14 Press and hold the engine start button for
approximately 5 seconds to shut off the
engine and to save the calibration settings.
Note: Do not turn the engine off with the key switch
or red Emergency Stop button or all calibration
points or values will not be saved.
Part No. 218700
15 Wait approximately 20 seconds and turn the
machine off by pressing the red Emergency
Stop button in.
16 Remove the fastener that was temporarily
installed. Close the control box door and
install the door retaining fasteners.
Note: When the control box door is closed, the
calibration toggle switch is automatically activated
to exit out of calibration mode.
17 Use the key to turn the service/bypass key
switch to the run position.
Note: Be sure that the service/bypass key switch is
in the run position before attempting to operate the
machine.
1 Run
2 Service / Bypass
3 Recovery
ZX-135/70
Service Manual
Axle Components
199