Bodily Injury Hazard. Spraying - Genie ZX-135/70 Service Manual

August 2014
4 Fill the hub with oil from upper plug hole until
the oil level is even with the bottom of the
middle plug hole. Install the plugs. Refer to
Specifications, Fluid Capacity Specifications.
5 Repeat steps 1 through 4 for all the other
drive hubs.
Turntable Rotate Drive Hub:
1 Secure the turntable from rotating with the
turntable rotation lock pin.
2 Tag, disconnect and plug the hydraulic hoses
to the drive hub drive motor and brake for
each drive hub assembly.

Bodily injury hazard. Spraying

hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
3 Attach a suitable lifting device to the lifting eye
of one turntable rotate drive hub assembly.
4 Remove the drive hub mounting bolts from
one drive hub assembly. Carefully remove the
turntable rotate drive hub assembly from the
machine. Do not remove both turntable rotate
drive hub assemblies at the same time.
Crushing hazard. The turntable
rotate drive hub assembly could
become unbalanced and fall
when removed from the machine
if not properly supported by the
lifting device.
Part No. 218700
Checklist D Procedures
1 drive hub mounting bolts
2 drive hub plug
5 Remove the plug from the side of the drive
hub. Drain the oil from the hub into a suitable
container.
6 Install the drive hub assembly onto the
machine. Lubricate and torque the drive hub
mounting bolts to specification. Refer to
Specifications, Machine Torque
Specifications.
ZX-135/70
Service Manual
67