Genie ZX-135/70 Service Manual page 113

Service Manual
Platform Controls
Function speeds:
Note: Be sure the machine is in the stowed
position and the boom is rotated between the circle
end tires.
Note: Perform this procedure with the machine on
a firm, level surface that is free of obstructions.
Note: Unless the LCD screen displays NOT
CALIBRATED, it will be necessary to enter the
valve calibration menu.
12 Start the engine from the platform controls.
13 Select a function that needs the function
speed set.
14 Primary boom up/down and extend/retract
functions: Move the joystick full stroke in the
up or extend direction. When the alarm
sounds, move the joystick in the opposite
direction full stroke until the alarm sounds
again. Return the joystick to center.
Secondary boom up and down functions:
Starting from the stowed position, move the
joystick full stroke in the up direction. When the
alarm sounds, move the joystick in the down
direction full stroke until the alarm sounds
again. Return the joystick to center
98
Turntable rotate function, fully retracted:
Move the rotate joystick full stroke in either
the left or right direction until the alarm sounds.
Return the joystick to center.
Turntable rotate function, primary boom
extended: Extend the primary boom
approximately 4 ft / 1.2 m. Move the rotate
joystick full stroke in either the left or right
direction until the alarm sounds. Return the
joystick to center.
Turntable rotate function, primary and jib
booms extended: With the primary boom
extended approximately 4 ft / 1.2 m, extend
the jib boom approximately 1 ft / 0.3 m. Move
the rotate joystick full stroke in either the left
or right direction until the alarm sounds.
Return the joystick to center.
15 Once the function speeds have been set,
press and hold the engine start button until
the engine shuts off. Do not press the red
Emergency Stop button.
Note: Approximately 3 seconds after the engine
shuts off, the alarm at the ground controls will
sound to indicate the settings are being saved in
memory.
16 At the ground controls, turn the key switch to
the off position, wait a moment and then turn
the key switch to platform controls.
17 Check the display at the ground controls to be
sure there are no calibration faults.
Note: There should be no calibration faults shown
on the display. If calibration faults exist, repeat this
procedure.
ZX-135/70
August 2014
Part No. 218700