Genie ZX-135/70 Service Manual page 115

Service Manual
Platform Controls
How to Adjust the Function Ramp
Rate Setting
The ramp rate setting of a joystick controls the time
at which it takes for the joystick to reach maximum
output, when moved out of the neutral position.
The ramp rate settings of a joystick can be
changed to compensate for hydraulic pump wear
to maintain peak performance from the machine.
Note: Perform this procedure with the boom in the
stowed position.
Note: Use the following chart to identify the
description of each LCD screen control button
used in this procedure.
Plus Minus
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
2 Press and hold the enter button on the
ground control panel while turning the key
switch to platform controls. Hold the enter
button for approximately 5 seconds.
3 Press the plus button twice, then press the
previous button twice.
100
Previous Enter
ZX-135/70
4 Press the previous button until the function to
be adjusted is displayed.
5 Press the plus button to increase the ramp
rate or press the minus button to decrease
the ramp rate.
6 Press the enter button to save the setting in
memory.
7 Press the enter or previous button on the
LCD screen until EXIT is displayed.
Press the plus button or minus button to
8
select YES and then press the enter button.
August 2014
Part No. 218700