Telematics Connector Pin Legend - Genie ZX-135/70 Service Manual

August 2014
Genie installed Telematics connector is wired with an Active High digital input.
Note: A Deutsch plug p/n DT06-08SA mates with the Genie Telematics connector
Pin Circuit Type
1 System Power
2 System Ground
3 Digital Output 1
4 No Connection
5 Digital Output 3
6 Digital Input 1
7* Databus H
8* Databus L
*Note: Genie Databus Proprietary message support will be available at a future date, consult Genie
Product Support for more information.
Remote Disable Relay Configuration: Telematic device software should monitor that Pin 3 is at 0V
before activating Disable Relay.
Wireless Certifications
Telematic device(s) should comply with specific wireless carrier certifications where applicable and comply with the
following:
North America
Europe
Part No. 218700

Telematics Connector Pin Legend

Connector Pin Numbering
Circuit Properties Genie Machine Function(s)
8-32 VDC Battery Positive – constant power
5 Amp Max. allowed
draw
0 VDC Battery Negative
12 VDC Engine Run Hour Meter
12V = engine run, 0V = engine off
Used on other units No Connection
12 VDC Footswitch
*12V = active, 0V = inactive
12 VDC Remote Machine Disable
*Configurable Active High or Active
Low via wiring at the Disable Relay
CAN HIGH Genie Databus
CAN LOW Genie Databus
PTCRB, FCC/IC
CE, R&TTE
ZX-135/70
Service Manual
Telematics Use Case
Supply power to device
Device GND
Monitor Engine Hours
Monitor machine utilization
Remote Engine Shutdown
J1939 Engine Messages, Receive
Proprietary Genie Telematics
Message
J1939 Engine Messages, Receive
Proprietary Genie Telematics
Message
241