Inspect The Tires, Wheels And Lug Nut Torque - Genie S-105 Service Manual

June 2011
REV E
a
a engine pivot plate anchor hole
b engine pivot plate retaining fastener
2 Locate the engine pivot plate anchor hole at the
pivot end of the engine pivot plate.
3 Install the bolt that was just removed into the
anchor hole to secure the engine pivot plate
from moving.
Crushing hazard. Failure to install
the bolt into the engine pivot plate
to secure it from moving could
result in death or serious injury.
4 Be sure that all fasteners are tight.
5 Inspect all welds for cracks.
6 Inspect for exhaust leaks; i.e., carbon buildup
around seams and joints.
7 Remove the engine pivot plate retaining fastener
from the engine pivot plate anchor hole at the
pivot end of the engine pivot plate.
8 Swing the engine pivot plate in towards the
machine.
9 Install the bolt that was just removed into the
original hole to secure the engine pivot plate.
Crushing hazard. Failure to install
the bolt into the engine pivot plate
to secure it from moving could
result in death or serious injury.
Part No. 102916
B-9
Inspect the Tires, Wheels
and Lug Nut Torque
Genie requires that this procedure be performed
b
every 250 hours or quarterly, whichever comes
first.
Maintaining the tires and wheels in good
condition, including proper wheel fastener torque, is
essential to safe operation and good performance.
Tire and/or wheel failure could result in a machine
tip-over. Component damage may also result if
problems are not discovered and repaired in a
timely fashion.
Note: The tires on these machines are foam filled
and do not need air added to them.
1 Check all tire treads and sidewalls for cuts,
2 Check each wheel for damage, bends and
3 Check each lug nut for proper torque. Refer to
S-100 • S-105 • S-120 • S-125
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
cracks, punctures and unusual wear.
cracked welds.
Section 2, Specifications .
3 - 23