Inspect The Tires, Wheels And Lug Nut Torque; Confirm The Proper Brake Configuration - Genie Z-34/22 Service Manual

Service Manual
Checklist B Procedures
B-4
Inspect the Tires, Wheels and
Lug Nut Torque
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Maintaining the tires and wheels, including proper
wheel fastener torque, is essential to safe
operation and good performance. Tire and/or
wheel failure could result in a machine tip-over.
Component damage may also result if problems
are not discovered and repaired in a timely fashion.
Bodily injury hazard. An
over-inflated tire can explode
and could cause death or serious
injury.
Tip-over hazard. Do not use
temporary flat tire repair
products.
Note: The tires on some machines are foam-filled
and do not need air added to them.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracked welds.
3 Check each lug nut for proper torque. Refer to
Specifications, Machine Specifications.
4 Check the pressure in each air-filled tire.
30
B-5
Confirm the Proper Brake
Configuration
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Proper brake configuration is essential to safe
operation and good machine performance.
Hydrostatic brakes and hydraulically-released,
spring-applied individual wheel brakes can appear
to operate normally when they are actually not fully
operational.
1 Check each drive hub disconnect cap to be
sure it is in the engaged position.
1 brake disengaged position
2 brake engaged position
Z-34/22 Bi-Energy
April 2016
Part No. 139234