Genie ZX-135/70 Service Manual page 249

Service Manual
Limit Switches and Angle Sensors
Rotary Sensor Functions
RSP1AO: Rotary Sensor, Primary #1 Angle
Operational. Provides operational primary boom
angle positioning relative to secondary boom
angle.
RSP1AS: Rotary Sensor, Primary #1 Angle Safety.
Provides safety primary boom angle positioning
relative to secondary boom angle.
RSJ1AO: Rotary Sensor, Jib #1 Angle Operational.
Used to level jib bell crank relative to the primary,
secondary and turntable angles.
RSS1AO: Rotary Sensor, Secondary #1 Angle
Operational. Used to measure the angle of the
secondary boom. Lowers drive speed when
elevated, sequences secondary boom up/extend
and down/retract.
RSS1AS: Rotary Sensor, Secondary #1 Angle
Safety. Backup safety angle sensor for RSS1AO.
Cuts power to circuits P9B, P_11 and P_30 if the
secondary boom drifts down while still extended.
RSFA1O: Rotary Sensor, Front Axle #1
Operational. Provides front axle positioning
information for adjusting steering neutral setting
during axle extension.
234
RSRA1O: Rotary Sensor, Rear Axle #1
Operational. Provides front axle positioning
information for adjusting steering neutral setting
during axle extension.
RSLF1SO: Rotary Sensor, Left Front #1 Steer
Operational. Provides wheel position information
during steering. Master wheel in all steer modes
except rear steer.
RSRF1SO: Rotary Sensor, Right Front #1 Steer
Operational. Provides wheel position information
during steering.
RSLR1SO: Rotary Sensor, Left Rear #1 Steer
Operational. Provides wheel position information
during steering. Master wheel for rear steer mode.
RSRR1SO: Rotary Sensor, Right Rear #1 Steer
Operational. Provides wheel position information
during steering.
ZX-135/70
August 2014
Part No. 218700