Genie ZX-135/70 Service Manual page 103

Service Manual
Display Module
Screen or Menu
Sensor Calibration
88
Procedure
With key switch , press
OFF
and hold the enter button
and turn key switch to on
position.
Release the enter button
and press
(plus)(enter)(enter)(plus).
Description
Set unit X-axis to gravity
Set unit Y-axis to gravity
Set platform level to gravity (YES/NO)
YES: Set platform level to gravity (YES/NO)
Platform level sensor millivolts/degree
Delete axles angle sensors calibration? (YES/NO)
YES: Axle angle fully retracted (YES/NO)
YES: Axle angle fully extended (YES/NO)
Delete all steer sensors calibrations? (YES/NO)
Delete blue end blue side steer sensor (FL)
calibration? (YES/NO)
Delete yellow end blue side steer sensor (RL)
calibration? (YES/NO)
Delete blue end yellow side steer sensor (FR)
calibration? (YES/NO)
Delete yellow end yellow side steer sensor (RR)
calibration? (YES/NO)
Delete secondary boom angle sensor calibration?
(YES/NO)
secondary boom angle to gravity -3.5°
secondary boom angle to gravity 20°
secondary boom angle to gravity 35°
secondary boom angle to gravity 50°
secondary boom angle to gravity 65°
secondary boom angle to gravity 76°
Delete primary boom angle sensor calibration?
(YES/NO)
primary boom angle to gravity 0°
primary boom angle to gravity -50°
primary boom angle to gravity -20°
primary boom angle to gravity 10°
primary boom angle to gravity 40°
primary boom angle to gravity 70°
Delete level angle sensor calibration? (YES/NO)
jib level calibration deg to gravity 60°
jib level calibration deg to gravity 34°
jib level calibration deg to gravity 8°
jib level calibration deg to gravity -18°
jib level calibration deg to gravity -44°
jib level calibration deg to gravity -70°
ZX-135/70
August 2014
Range or
Selection
Use +/- buttons
to adjust
Part No. 218700