Genie ZX-135/70 Service Manual page 207

Service Manual
Axle Components
Left front (square-end, blue side) and right rear
(circle-end, yellow side) angle sensors:
Illustration 2
1 starting position
2 installed position
3 sensor cover
4 rotation arrow
4 Position the new steer sensor assembly over
the sensor activator pin with the sensor cable
angled towards the tire. Refer to Illustration 2.
5 Align the sensor with the pin and install the
sensor on to the pin.
Note: Be sure the sensor activator pin is engaged
into the sensor.
6 Rotate the sensor housing in a clockwise
direction until the sensor cable is pointing
away from the machine. Refer to Illustration 2.
192
7 Install the steer sensor cover retaining
fasteners. Do not tighten the cover retaining
fasteners.
8 Connect the steer sensor assembly cable to
the main harness.
9 Calibrate the steer sensor. See How to
Calibrate a Replacement Steer Sensor in this
section.
Note: Be sure the yoke pivot pin retaining plate is
fully engaged into the pivot pin and that the
fasteners are securely tightened.
Right front (square-end, yellow side) and left
rear (circle-end, blue side) angle sensors:
1 installed position
2 starting position
3 sensor cover
4 rotation arrow
ZX-135/70
August 2014
Illustration 3
Part No. 218700